|
Post by bryansemple on Jan 31, 2013 18:45:37 GMT -6
I have a Watts dual temp thermo stat. The settings allow for a timer to control the thermostat and set it back when 24 VAC is applied (at least that is what I believe based on an older instruction sheet I found). But the current instructions do not list where to apply this 24 VAC to enable setback. Can someone provide the wiring instructions for where to connect this?
Thanks
|
|
|
Post by cdeleo on Jan 9, 2014 15:52:40 GMT -6
bryansemple,
Just wondering if you ever figured out if in fact it was a 24 vac signal? I sent one to my thermostat and it did switch it to the set back but it also through off the temperature reading due to a resister getting hot. thermostat read about 2 deg. f above actual temp.
Thanks,
Chris
|
|